150mm Stainless Steel Pumps - Binda 6D Series

Motor: C.R.I. 150 mm Borewell submersible pump sets are powered by water filled, rewindable submersible motor which is suitable for continuous duty. The stator is wound with special waterproof synthetic film insulated copper winding wires and made up of low watt loss silicon steel laminations assembled under pressure and rigidly locked in stainless steel stator shell. T-Bolt design in all motors ensures rigid construction.

C.R.l.’s new double depth BINDA 6D+ 150 mm Borewell submersible pumps are specially designed for conditions where the ground water level is too deep. This series guarantees long life with energy-efficient performance. The built in check valve prevents back flow, and reduces the risk of water hammer.

BROCHURE
REQUEST A QUOTE
REQUEST A QUOTE
REQUEST A QUOTE

Name*
Email*

Phone*
City*
Pincode*
Product
Message
By continuing you agree to CRI Terms & conditions and privacy policy
CAPTCHA
Phone
This field is for validation purposes and should be left unchanged.

Double working capacity compared to other pump sets
Corrosion resistant SS 304 stage casing SS 410 impeller increases the life of pump
Helps to lift water from higher depth with reduced number of stages.
Carbon Teflon pads are used to withstand the up thrust load.
Specially designed Thrust Bearings to withstand high axial thrust loads
High operating efficiency and consistent performance ensures low operation cost
Motor is designed with higher cooling effect by increasing the housing areas.

Power Range	2.2 kW - 22 kW (3 HP - 25 HP)
Voltage Range	3Ph - 380 - 415V, AC Supply
Maximum Total Head	500 Metre
Maximum Flow Rate	20 lps (72 m3/hr)

Part Name	Material
Suction Housing	Cast Iron with SS 410 Top Plate
Impeller	SS 410
Pump Shaft	SS - 410
Motor Base	Cast iron